Optimal Energy Allocation for Wireless Communications with Energy Harvesting Constraints

We consider the use of energy harvesters, in place of conventional batteries with fixed energy storage, for point-to-point wireless communications. In addition to the challenge of transmitting in a channel with time selective fading, energy harvesters provide a perpetual but unreliable energy source. In this paper, we consider the problem of energy allocation over a finite horizon, taking into account channel conditions and energy sources that are time varying, so as to maximize the throughput. Two types of side information (SI) on the channel conditions and harvested energy are assumed to be available: causal SI (of the past and present slots) or full SI (of the past, present and future slots). We obtain structural results for the optimal energy allocation, via the use of dynamic programming and convex optimization techniques. In particular, if unlimited energy can be stored in the battery with harvested energy and the full SI is available, we prove the optimality of a water-filling energy allocation solution where the so-called water levels follow a staircase function.Comment: 27 pages, 6 figures, accepted for publications at IEEE Transactions on Signal Processin

Wireless Information and Power Transfer: Architecture Design and Rate-Energy Tradeoff

Simultaneous information and power transfer over the wireless channels potentially offers great convenience to mobile users. Yet practical receiver designs impose technical constraints on its hardware realization, as practical circuits for harvesting energy from radio signals are not yet able to decode the carried information directly. To make theoretical progress, we propose a general receiver operation, namely, dynamic power splitting (DPS), which splits the received signal with adjustable power ratio for energy harvesting and information decoding, separately. Three special cases of DPS, namely, time switching (TS), static power splitting (SPS) and on-off power splitting (OPS) are investigated. The TS and SPS schemes can be treated as special cases of OPS. Moreover, we propose two types of practical receiver architectures, namely, separated versus integrated information and energy receivers. The integrated receiver integrates the front-end components of the separated receiver, thus achieving a smaller form factor. The rate-energy tradeoff for the two architectures are characterized by a so-called rate-energy (R-E) region. The optimal transmission strategy is derived to achieve different rate-energy tradeoffs. With receiver circuit power consumption taken into account, it is shown that the OPS scheme is optimal for both receivers. For the ideal case when the receiver circuit does not consume power, the SPS scheme is optimal for both receivers. In addition, we study the performance for the two types of receivers under a realistic system setup that employs practical modulation. Our results provide useful insights to the optimal practical receiver design for simultaneous wireless information and power transfer (SWIPT).Comment: to appear in IEEE Transactions on Communication

Recent Advances in Joint Wireless Energy and Information Transfer

In this paper, we provide an overview of the recent advances in microwave-enabled wireless energy transfer (WET) technologies and their applications in wireless communications. Specifically, we divide our discussions into three parts. First, we introduce the state-of-the-art WET technologies and the signal processing techniques to maximize the energy transfer efficiency. Then, we discuss an interesting paradigm named simultaneous wireless information and power transfer (SWIPT), where energy and information are jointly transmitted using the same radio waveform. At last, we review the recent progress in wireless powered communication networks (WPCN), where wireless devices communicate using the power harvested by means of WET. Extensions and future directions are also discussed in each of these areas.Comment: Conference submission accepted by ITW 201

Spectral Efficiency and Energy Efficiency of OFDM Systems: Impact of Power Amplifiers and Countermeasures

In wireless communication systems, the nonlinear effect and inefficiency of power amplifier (PA) have posed practical challenges for system designs to achieve high spectral efficiency (SE) and energy efficiency (EE). In this paper, we analyze the impact of PA on the SE-EE tradeoff of orthogonal frequency division multiplex (OFDM) systems. An ideal PA that is always linear and incurs no additional power consumption can be shown to yield a decreasing convex function in the SE-EE tradeoff. In contrast, we show that a practical PA has an SE-EE tradeoff that has a turning point and decreases sharply after its maximum EE point. In other words, the Pareto-optimal tradeoff boundary of the SE-EE curve is very narrow. A wide range of SE-EE tradeoff, however, is desired for future wireless communications that have dynamic demand depending on the traffic loads, channel conditions, and system applications, e.g., high-SE-with-low-EE for rate-limited systems and high-EE-with-low-SE for energy-limited systems. For the SE-EE tradeoff improvement, we propose a PA switching (PAS) technique. In a PAS transmitter, one or more PAs are switched on intermittently to maximize the EE and deliver an overall required SE. As a consequence, a high EE over a wide range SE can be achieved, which is verified by numerical evaluations: with 15% SE reduction for low SE demand, the PAS between a low power PA and a high power PA can improve EE by 323%, while a single high power PA transmitter improves EE by only 68%.Comment: to be published, IEEE J. Sel. Areas Commu

Data Offloading in Load Coupled Networks: A Utility Maximization Framework

We provide a general framework for the problem of data offloading in a heterogeneous wireless network, where some demand of cellular users is served by a complementary network. The complementary network is either a small-cell network that shares the same resources as the cellular network, or a WiFi network that uses orthogonal resources. For a given demand served in a cellular network, the load, or the level of resource usage, of each cell depends in a non-linear manner on the load of other cells due to the mutual coupling of interference seen by one another. With load coupling, we optimize the demand to be served in the cellular or the complementary networks, so as to maximize a utility function. We consider three representative utility functions that balance, to varying degrees, the revenue from serving the users vs the user fairness. We establish conditions for which the optimization problem has a feasible solution and is convex, and hence tractable to numerical computations. Finally, we propose a strategy with theoretical justification to constrain the load to some maximum value, as required for practical implementation. Numerical studies are conducted for both under-loaded and over-loaded networks.Comment: 12 pages, accepted for publication in IEEE Transactions on Wireless Communication

The Multi-Sender Multicast Index Coding

We focus on the following instance of an index coding problem, where a set of receivers are required to decode multiple messages, whilst each knows one of the messages a priori. In particular, here we consider a generalized setting where they are multiple senders, each sender only knows a subset of messages, and all senders are required to collectively transmit the index code. For a single sender, Ong and Ho (ICC, 2012) have established the optimal index codelength, where the lower bound was obtained using a pruning algorithm. In this paper, the pruning algorithm is simplified, and used in conjunction with an appending technique to give a lower bound to the multi-sender case. An upper bound is derived based on network coding. While the two bounds do not match in general, for the special case where no two senders know any message bit in common, the bounds match, giving the optimal index codelength. The results are derived based on graph theory, and are expressed in terms of strongly connected components.Comment: This is an extended version of the same-titled paper accepted and to be presented at the IEEE International Symposium on Information Theory (ISIT), Istanbul, in July 201